How to use
?

Bob easytap is a diverter to be installed at the end of your tap to fill your dishwasher (compatible with all dishwashers) automatically thanks to the water inlet hose Bob easywater.
Step 1 : Unscrew the tap ring

Unscrew the ring of your faucet by turning clockwise.
Step 2 : Determine your type of faucet: Male or female?
Male tap

If your faucet thread is on the outside, then you have a male tap.
➡ You can connect Bob easytap without using the supplied adapter.
1

2

Female tap

If your faucet thread is on the inside, then you have a female tap.
➡ You must add the supplied male adapter.
1

2

3

4

Step 3 : Install
to 
1

2

Screw Bob easywater to Bob easytap clockwise.
Water opening

Position 1: Fill Bob
- Tap open
- Bob easytap in a horizontal position
- Start a wash cycle
➡ Water flows in Bob.

Position 2: Use tap
- Tap open
- Bob easytap in a vertical position
➡ Water flows into the sink.
Water shut off

Closed position
- Tap closed
- Bob easytap in vertical position
➡ The water is blocked.
⚠️ WARNING
Be sure to close your tap after each use to avoid any risk of leakage.