Bob’s connections
Water inlet connection :
2 available options
1
Plug the water inlet hose on one side to the back of Bob and on the other side to a water inlet via a 19 mm threaded end (3/4 inch) and make sure the connection is firmly tightened.
2
Using Bob as an autonomous freestanding dishwasher thanks to its built-in water tank. In this case, no water inlet hose is needed! Please use Bob Carafe to quickly fill the water tank! Bob can be filled with either cold or hot water up to 60°C.
Water outlet connection:
Plug the water drain hose to the back of Bob
To prevent leaks, please use the provided clamp to fix the water outlet.
2 options for evacutaing the waste water
1 Siphon drain pipe
Connect the water outlet hose to a siphon drain pipe (usually accessible under the sink)
Warning: The waste water coming out of Bob can reach high temperature of up to 70°C.
2
Install the water outlet drain hose either in a fixed or flexible mode by using the equipment provided by Daan Tech.
Fixed installation
Place the drain hose directly in your sink and fix it with the equipment provided by Daan Tech
Flexible installation
Place the drain hose in a container (jerrican, bucket, etc…)
Power plug :
Connect the power cable to Bob’s back and connect the power cable to a 100-120V 60Hz plug.
Before you connect Bob to the power supply, please make sure that the voltage on the type plate corresponds to the voltage of your power supply.
Do not plug or unplug by pulling the cord, but always pull the plug directly
The content of this page is presented for information only, it does not in any way constitute a complete notice. For more information, please refer to Bob’s user guide.